Details
Industrial Subcategory:
Abrasive Wheels, Discs and Brushes
Materials that can be worked:
Materials that can be worked 1:
Materials that can be worked 10:
Steel materials with a hardness > 54 HRC
Materials that can be worked 11:
Steels up to 370 HV (< 38 HRC)
Materials that can be worked 12:
Materials that can be worked 13:
Materials that can be worked 14:
Materials that can be worked 2:
Materials that can be worked 3:
Materials that can be worked 4:
Materials that can be worked 5:
Materials that can be worked 6:
Fibre-reinforced thermosetting plastics (GRP, CRP)
Materials that can be worked 7:
Hardened, heat-treated steels over 370 HV (38 HRC)
Materials that can be worked 8:
Nickel-based alloys (e.g. Inconell and Hastelloy)
Materials that can be worked 9:
Recommendations for use:
For the best performance, use with a recommended peripheral speed of 1,000-2,000 SFPM. This provides an ideal compromise between stock removal rate, surface quality, thermal load on the workpiece and tool wear.
Recommendations for use 1:
Use diamond polishing pastes and polishing paste bars.
Recommendations for use 2:
When applying a different polishing paste, use a new unused polishing product.
Recommendations for use 3:
Use the soft type for buffing and processing workpieces with lots of contours.
Recommendations for use 4:
If a very fine finish is desired, the soft and hard versions can be used successively.
Safety notes:
For safety reasons, the maximum permitted rotational speed indicated must never be exceeded.
Manufactured By:
Pferd Inc.
Other Details
Can be freely shaped, meaning they can be used on complicated geometries.
Low thermal load on the workpiece.
Precise retention of geometric shapes due to the hardness of these products.